IT RU ES

Isola gold

ASSEMBLY with glues to standard UNI EN 204-04.

MAIN FRAME profile section 92 x 85 mm with three rabbets, rounded edges.

OPENING SASHES 3-rabbet profile section 92 x 85 mm, with rounded edges, lower crossbar with weep holes at the drip bar, to drain any condensate from the glazing, including the glazing beads.

INSULATION Heat and noise insulation, water and air sealing. Guaranteed by three heat and noise proof gaskets EPDM, welded at the corners, of which two inserted in the main frame and one on the shutter. A fourth gasket can be inserted in the glazing bead.

DRIP BAR In aluminium with plastic terminals (can be covered in wood). Heat barrier in aluminium and polyamide.

HARDWARE New generation hardware with 13 mm offset, hardware axis shifted towards the middle of the profile to increase the stability of the strike plate fastenings. This system ensures the window has greater resistance to pulling-out and burglary and that maintenance is simple and reduced.

air permeability
UNI EN 1026 (2001)
Class 4 (highest class)

water seal
UNI EN 1027 (2001)
Class E 1350 (beyond highest class)

wind resistance
UNI EN 12211 (2001)
Class C5 (highest class)

heat transmittance*
UNI EN ISP 10077-1 (2007)
Uw = 0,95 W/m2K

*Calculated on single-sash window size 1230 x 1480 mm with glazing
Ug = 0.7 W/m2K

Design and sections